Pentair AUTOTROL 360 Service Manual Download

Page: 2 / 12

TABLE OF CONTENTS

MANUAL OVERVIEW

How To Use This Manual

This manual is designed to guide the installer through the

process of installing and starting the filter.
This manual is a reference and will not include every system

installation situation. The person installing this equipment

should have:

• Knowledge in water filter installation
• Basic plumbing skills

Icons That Appear In This Manual

WARNING:

Failure to follow this instruction can result in

personal injury or damage to the equipment.

NOTE: This will make the process easier if followed.

Inspection

Inspect the unit for damage or missing parts.

SAFETY INFORMATION

Electrical (361 Only)

• There are no user-serviceable parts in the AC adapter,

motor, or controller. In the event of a failure, these should

be replaced.

• All electrical connections must be completed according to

local codes.

•  Use only the power AC adapter that is supplied.
•  The power outlet must be grounded and always on.
•  To disconnect power, unplug the AC adapter from its

power source.

• Install an appropriate grounding strap across the inlet

and outlet piping of the water system to ensure proper

grounding is maintained.

Mechanical

• Do not use petroleum-based lubricants such as

petroleum jelly, oils, or hydrocarbon-based lubricants.

Use only 100% silicone lubricants.

• All plastic connections should be hand tightened.

Plumber tape should be used on connections that do not

use an O-ring seal. Do not use pliers or pipe wrenches.

• All plumbing must be completed according to local codes.
• Soldering of the plumbing should be done before

connecting to the valve. Excessive heat will cause interior

damage to the valve.

• Observe local drain line requirements.
• Do not use lead-based solder for sweat solder

connections.

• Do not support the weight of the system on the control

valve fittings, plumbing, or the bypass.

• It is not recommended to use sealants on the threads.

Use plumber tape (PTFE) on all threads.

General

• Observe all warnings that appear in this manual.
• This system is not intended to be used for treating water

that is microbiologically unsafe or of unknown quality

without adequate disinfection before or after the system.

• Keep the unit in the upright position. Do not turn on side,

upside down, or drop. Turning the tank upside down will

cause media to enter the valve.

• Operating ambient temperature is between 34°F (1°C)

and 120°F (49°C).

• Operating water temperature is between 34°F (1°C) and

100°F (38°C).

• Working water pressure range is 20 to 125 psi

(1.38 to 8.61 bar).

• Follow state and local codes for water testing.
• When filling media tank, do not open water valve

completely. Fill tank slowly to prevent media from exiting

the tank.

• Always make modifications to house plumbing first.

Connect to valve last.

• Plastic parts and O-rings may be damaged by heat and

solvents. When constructing plumbing connections, allow

heated parts to cool and protect parts from solvents.

Location Selection

Location of a water treatment system is important. The

following conditions are required:

•  Level platform or floor.
•  Constant electrical supply to operate the controller.
•  Total minimum pipe run to water heater of ten feet (three

meters) to prevent backup of hot water into system.

•  Local drain or tub for discharge as close as possible.
•  Water line connections with shutoff or bypass valves.
•  Room to access equipment for maintenance.

CALIFORNIA PROPOSITION 65 WARNING

WARNING:

This product contains chemicals known to the

State of California to cause cancer or birth

defects or other reproductive harm.

2 •

AUTOTROL

360/361 Filter Valves