Pentair Pool Products MiniMax NT Standard 200, Operation & Installation Manual

Page: 22 / 32

P/N 472032 Rev. A 1-2-02
22
OFF SPA POOL
SET
MODE
PROGRAM
TEMP
TEMP
STEP Increase
Raise
( )
Decrease
Lower
( )
1. Before changing the temperature, make sure the “ Temperature ” is in the right window, see pages 22
and 23, if “ Time ” is displayed, press the MODE key to change to the “Temperature Mode” .
2. To change the Pool Temperature setting, press the POOL key.
SET
MODE
PROGRAM
TEMP
TEMP
STEP
until the desired setting is displayed.
NOTE: During Programming of the Pool Temperature , the two buttons on the
right are used to or the display setting numbers.
NOTE: Pool Temperature is now set.
4. You can leave the right window displaying the set “ Temperature ” or by pressing
the MODE key, you can return to the “ Time ” Mode.
NOTE: To re-set the Spa Temperature , follow the above steps 1. through 4.
while in the “ Spa Heating ” Mode.
3. To Raise or Lower the Pool Temperatur e setting, press the proper TEMP key
TEMP
TEMP
STEP
OFF SPA POOL
Increase
Raise
( )
Decrease
Lower
( )
TO CHANGE THE FACTORY TEMPERATURE SETTINGS:
TIME SETTING
1. Make sure heater is turned “OFF” and not in the POOL or SPA “ON” Mode.
2. Place the Controller in Programming Mode by depressing the SET and MODE buttons at the same time.
NOTE: During Programming of the Time Setting , the two buttons on the right
are used to or the display setting numbers.
Temperature & Time Setting (Programming)