Pentair Pool Products Kreepy kadet, Owner'S Manual

Page: 9 / 15

V. Troubleshooting
Because of the individual characteristics of your pool, some additional adjustments may be required to
get the best performance from your Kreepy Kadet.
If there seems to be a problem, check these common causes of cleaner problems. If you still need help,
call your pool professional or call our Customer Helpline at 1-800-443-5711.
– Is bottom main drain closed? Close drain
– Is filter clean? Clean filter
– Is pump strainer basket clean? Clean basket
– Is debris blocking the bottom of the cleaner? Remove debris
– Are there any leaks in the hose? Replace leaky section
– Is automatic regulator valve free of debris? Clean valve
If Kreepy Kadet is not moving or not pulsating.
• Check to ensure that the main drain and all suction lines are closed, except for the suction line
to which the cleaner is attached.
• Check for debris in the filter or pump basket.
• Check for debris in the cleaner’s flapper. See page 14 for instructions.
• Pool pump and filter system may be too small (incapable of providing 14 gallons per minute
of water flow). Consult your pool professional.
If Kreepy Kadet slows or stops and air bubbles enter the pool at the return line.
Find and correct the air leak that is causing the pump to lose its prime:
• Check the hose to ensure there are no leaks.
• Check the vacuum connection. It should be submerged so no air enters the system.
• Check the pump basket lid for looseness, cracks, worn or missing O-rings. If you need
assistance, contact your pool professional.
If Kreepy Kadet stays in one end of the pool.
• Check the return line water flow and re-direct as necessary with an eyeball diverter.
• Check that the hose is long enough to reach to the farthest end of the pool, plus one section.
If Kreepy Kadet stays on the main drain.
• Check to ensure that the main drain is closed.
• Check to ensure that a main drain grate is installed.
• If main drain is not flush with the pool floor, consult a pool professional.
If Kreepy Kadet pulls air from, or remains at, the water surface.
• Check to ensure the dive float mechanism is securely attached.
• Check automatic regulator valve for its proper installation and ensure it is not
clogged with debris.
• Make sure the water level is at least 3 inches below the pool deck.