Cascade Comfort System
8
WARNING
In addition to monitoring the temperature readout, always check the water
temperature by allowing it to run over your wrist. Failure to do this could result in a
hot-water burn to the resident.
Using Cascade Comfort Bathing System
Reference page 5 for locations of the controls listed in this section.
WARNING
Failure to manually check the water temperature before putting a resident in the spa
may result in burn injuries to the resident and/or operator.
1.
Push the Tub Fill button located on the Cascade Comfort Control Panel and adjust the water
temperature by turning the Temperature Control knob to normal bathing temperature, 95
to105 degrees Fahrenheit (35 to 41 degrees Celsius).
2.
When water reaches the overflow push Tub Fill button again to shut water off.
3.
Press and hold the up button and recline the resident until you have reached a position suitable
for resident bathing.
Bathing Procedure
You are now ready to begin washing the resident. The suggested bathing time is 5 to 10
minutes. Bathing a patient more than 10 minutes is not required.
To bathe the resident, use the following procedures:
(Reference Figure 1 for the location of the controls listed in this section)
After resident is comfortable in spa you can recline the spa using the up and down buttons
pictured on page 5 of this manual.