2.0 USER INSTRUCTIONS - MANUAL CONTROL
The unit may be operated by hand if there is a defect in the remote control. To do so, the ignite (piezo) cable of
the receiver must first be removed and carefully slid into the piezo connector on the gas control block.
2.1 Igniting the fire
Open the gas shut-off cock that has been installed in the gas pipe to the unit.
Press the “
O I
” switch, on the gas control block, to the “
I
” position.
Turn the main valve knob, on the gas control block, completely to the right. The button will make a "click”
sound.
Turn the manual knob on the gas control block into the “
MAN
” position. A metal circle in the knob will
become visible.
Push the metal circle inwards using a small screwdriver or other instrument. Gas will now flow to the pilot
flame.
While keeping the metal circle pressed down, press the (square) piezo button (along the “
O I
” switch)
several times to ignite the pilot flame. You will be able to see whether the pilot flame is burning through
the glass window.
If the pilot flame is alight, keep the metal circle pressed down for another 10 seconds and then let go.
Turn the manual knob to the
ON
position. The burner may or may not ignite, depending on the
position of the main valve knob.
By turning the main valve knob to the required setting to the left, the burner will ignite and the flame size
can be adjusted.
2.2 Extinguishing the fire
Turn the main valve knob, on the gas control block, completely to the right. The button will make a "click” sound.
The burner will turn off. The pilot flame continues to burn.
2.3 Switching the unit off
Press the "
O I
” switch, on the gas control block, to the “
O
” position. The pilot flame will extinguish.
If the fireplace is not used for an extended period of time, we recommend closing the gas shut-off cock in the
supply line.
PAGE 6
Piëzo Ignitter (Manual)
Manual knob
Main valve knob
Microswitch
“
O I
” Switch
8 Wire Receiver Jack
Small metal circle for Manual ignition
Combination Control Cover Manual position
IMPORTANT: If the pilot light is extinguished, wait at least 5 minutes before repeating the steps
above.
