1.0 USER INSTRUCTIONS - REMOTE CONTROL
1.1 General
The unit is operated using a radio-controlled remote control. This consists of a manual transmitter
and a receiver. The receiver is connected to the gas control block.
The receiver and the gas control block are located behind the hinged panel on the front of the stove.
If there is no change in flame height for a 6-hour period the appliance will turn down to standby mode.
If the battery is low in receiver the systems shuts off the fire completely.
When in use with 220V adapter and the power shuts off, the batteries will take over the power
supply to let the receiver function normally.
Designated low and high fire settings:
Double click the small flame button and the flame will be automatically go to low flame.
Double click the large flame button and the flame will be automatically go to high flame.
Make sure the handset is switched off correctly to prevent battery drainage and loss of connectivity.
1.2 Manual transmitter
The transmitter uses a radio-controlled signal, the signal code is set at the factory
1.3 Screen setup
After the batteries have been inserted, press the
OFF
button and (small) at the same time to
toggle between °F (and 12 hour clock) and °C (and 24 hour clock).
Wait a moment or press
OFF
to return to
MAN
mode.
1.4 Setting the time
Press (large) and (small) at the same time to go to the
SET
mode or programming mode.
The time can be set while the screen is flashing.
Press (large) to set the hour and minutes.
Wait a moment or press
OFF
to return to
MAN
mode.
1.5 Setting the timer: P1 and P2 (THERMOSTAT VERSION ONLY)
Briefly press the
SET
button to select the required mode or
Keep the
SET
button pressed until the screen starts flashing.
Then press (large) or (small) to set the required temperature.
Wait a moment or briefly press the
OFF
button to select the
MAN
mode.
If the temperature setting also needs to be switched off (to reduce battery use),
Turn down until appears on the screen.
Once the temperatures have been set, the programme can be set by pressing the SET button.
Programme will appear. Keep the SET button pressed to set the time for the first on and
off programme. Set the time you want the unit to switch on. Then press the SET button to switch the unit
off.
Press SET again for the programme.
Set the time you want the unit to switch on. Then press the SET button to
switch the unit off.
Press SET again to see the current programme on the display.
PAGE 3
P1
P2
