Penguin Water PWXH-150, Manual

Page: 22 / 41

9. Now connect the brine line to the brine tank safety float assembly. Remove the brine
tank lid and the brine well cap. There is a red clip on the cap that will be used to hold
the brine line in place. Remove it, and the tape holding it, and put it to the side. Then
push the brine line through the brine tank and brine well. REMOVE the brass insert
for this connection. Push the brine line into the brine safety valve. Make sure it is
completely pushed in. Then install the red locking clip around the brine fitting be-
tween the gray collar and the brine elbow. Install the white cap on the tube.
10. Turn both bypass handles so they are perpendicular to the bypass to place the unit in
the bypass position. Slowly turn on the main water supply. At the nearest cold treated
faucet or spigot, open the faucet and let water run a few minutes or until the system
is free of any air or foreign material resulting from the plumbing work. If a faucet is
used, make sure the screen is removed first.
11. Make sure there are no leaks in the plumbing system before proceeding. Close the
water tap when water runs clean. Check for leaks again.
22