Arctica 4804iq Series switch Installation Guide Chapter 2 Installation Notice
■
Provide electromagnetic shielding if necessary.
2.1.6.Rack Configuration
The dimensions of the Arctica 4804iq series are designed to be mounted on a
standard 19’’ rack, please ensure good ventilation for the rack.
■
Every device in the rack will generate heat during operation, therefore vent and fans
must be provided for an enclosed rack, and devices should not be stacked closely.
■
When mounting devices in an open rack, care should be taken to prevent the rack
frame from obstructing the switch ventilation openings. Be sure to check the
positioning of the switch after installation to avoid the aforementioned.
Caution
！
If a standard 19’’ rack is not available, the Arctica 4804iq series can be placed on a
clean level desktop, leave a clearance of 100mm around the switch for ventilation, and
do not place anything on top of the switch.
2.2.Installation Notice
■
Read through the installation instruction carefully before operating on the system.
Make sure the installation materials and tools are prepared. And make sure the
installation site is well prepared.
■
During the installation, users must use the brackets and screws provided in the
accessory kit. Users should use the proper tools to perform the installation. Users
should always wear antistatic uniform and ESD wrist straps. Users should use
standard cables and connecters.
■
After the installation, users should clean the site. Before powering on the switch,
users should ensure the switch is well grounded. Users should maintain the switch
regularly to extend the lifespan of the switch.
■
Statement indicating that a readily accessible disconnect device shall be
incorporated in the building installation wiring.
2.3.Security Warnings
■
When using SFP transceiver, do not stare directly at the fiber bore when the switch
is in operation. Otherwise the laser may hurt your eyes.
■
Do not attempt to conduct the operations which can damage the switch or which can
cause physical injury.
■
Do not install, move or disclose the switch and its modules when the switch is in
operation.
■
Do not open the switch shell.
■
Do not drop metals into the switch. It can cause short-circuit.
■
Do not touch the power plug and power socket.
■
Do not place the tinder near the switch.
