PenBits Bachmann Class 66, Assembly Instructions Manual, Page: 48 / 61

…and outer ends of the moulded frame to
fit over the etched Subframe and to
engage in the slots at the inner end of the
Subframe. If it is a tight fit for length over the
outward
projecting ends of the etched
Subframe, file a little off them to get a free fit,
to avoid distorting the Subframe.
Carefully reduce the section of the outer
cross member of the moulded frame to give
clearance for the wheels to be inserted
vertically from above.
Fettle the plastic cross pieces at the inner end of the frames, and the top edges of
the outer extensions of the etched subframe sides, to get the plastic frames to sit
level on the etched Subframe, with their wheel hubs aligned vertically and horizontally
with the axle centres. (For vertical alignment, the tops of the etched bearing carriers
should be level with the top edges of the Subframes).
Check that there is clearance between the
inner ends of the Drive Units and the plastic
frames. Thin the ends of the Drive Units
further, if required. (If the Drive Units are not
already in place, rest them in position on top of
their axle bearings).
Remove the wheelsets, Drive Units and frame mouldings from the Subframes.
Bachmann 66: Cosmetic Sideframes 48/60
(c) PenBits Model Railways, All Rights Reserved 27/09/2021