9
Reddi
= Attach wheel to fork and ensure quick release is seated
fully into the fork dropouts. Tighten screw nut until the quick
release lever is in closed position. (Look for the word “closed”
on the quick release when it is in it’s locked position). Please
see illustration. (note: Because of the cushy tires you may need
to wiggle the tire a bit past the brake on Reddi)
Rover & Reyes
= Rotate the stem 180 degrees so it is faceing
forward (Note: Stem is still loose and will be tightened when
installing the handlebar). Attach wheel to fork. When attaching
wheel to fork make sure to align the disc rotor with the caliper,
please see illustration below. Once the quick release is seated
fully in the front dropouts tighten screw nut until the quick
release lever is in the closed position (you should see the
word “closed” on the quick release when in locked position).
**Note: Do not squeeze front brake lever until wheel is installed.
Squeezing without the rotor in place may cause miss-alignment
with the disc pads and rotor.
Step 3/3 Continued
Align rotor and
caliper so rotor
slides between
caliper brake
pads
Axle is securely
seated in dropout