2
PREPARE THE DOOR FOR INSTALLATION
TWO OR MORE PEOPLE WILL BE REQUIRED TO HANDLE
THE PANEL AND FRAME SAFELY.
A.
Remove plastic wrap and cardboard packaging from door.
DO NOT remove
plastic shipping spacers. The shipping spacers will help keep the door square
during installation. DO NOT open the door until it is fully fastened.
If Attaching with fasteners through the Brickmould go to Step 3
Anchoring Method – (Installation Clip or Frame Screw Through Frame)
B.
Doors using Installation Clips:
Install installation clips. Place each clip so
the lip is facing up and against the brickmould at the locations shown in the
placement diagram. Secure each clip by driving a #6 x 5/8" corrosion resistant
screw through each of the outer two holes of the three holes shown.
Note: If clips are to be bent; pre-bend before attaching to frame.
Lip
#6 x 5/8" corrosion
resistant screws
2B
C.
Doors using Frame Screws:
Open door panels; drill and counter-sink 3/16"
diameter clearance holes through the door frame jambs, (head and sill of
sidelight units) but not into the rough opening at the locations shown. Where
applicable, clearance holes are drilled though open hinge screw holes and
each strike hole.
DOOR UNIT, JAMB TO JAMB
SIDELIGHT UNIT, HEAD TO SILL
SIDELIGHT UNIT, JAMB TO JAMB
Pilot Hole
Alternative Pilot Hole
for Screw Install
Pilot Hole
Alternative Pilot Hole
for Screw Install
Pilot Hole
Pilot Hole
Pilot Hole
Pilot Hole
