3
4
4
ASSEMBLE TWO (2) M8 X 30
CARRIAGE BOLTS THROUGH
RAIL NUTS TO NYLON RETAINER
WASHERS.
TEMPORARILY REMOVE ENDCAP
FROM RAIL AND SLIDE IN RAIL NUT
ASSEMBLIES. REPEAT FOR OTHER
MOUNT (4 RAIL NUTS TOTAL).
SLIDE NYLON RETAINER
WASHERS FIRMLY AGAINST RAIL
NUTS AND TIGHTLY SEAT SQUARE
BOLT FEATURES AS SHOWN.
ASSEMBLE TWO (2) SNAP STRIPS TO EACH FOOT:
• PRESS TWO (2) BLACK SNAP FACES TIGHTLY
TOGETHER.
• REMOVE TAPE LINER ON ONLY ONE SIDE.
• ENSURE MOUNTING FOOT SURFACE IS
CLEAN AND DEGREASED. LINE UP TAPE
SQUARE TO FOOT.
• PRESS THIS ADHESIVE FACE FIRMLY
ON ADJUSTABLE FOOT
• LEAVE TAPE LINER ON OTHER SIDE.
• TAKE CARE TO NOT TOUCH ADHESIVE
SURFACE WITH HANDS OR OBJECTS.
3
INSERT DETENT KNOB WITH LOWER ARM HORIZONTAL
ASSEMBLE SNAP STRIPS TO FEET
KNOB MUST BE THREADED FULLY IN, TO LOCK ARM HORIZONTALLY FOR SUPPORTING CASE.
REPEAT STEP FOR OTHER MOUNT SUBASSEMBLY.
TO AVOID SCRATCHING PAINT ON LOWER ARM, TAKE CARE TO ALWAYS UNTHREAD KNOB
SUFFICIENTLY TO CLEAR LOWER ARM BEFORE ROTATING.
3.1
DETENT KNOB
(Right Hand Thread)
3.2
VERTICAL: STOWED
DETENT
HOLES
KNOB
Lower arms have two (2) detent
holes that must be used for
locking in position :
One hole in horizontal position
to support case; one vertical, to
stow case (not-in-use).
Snap the black faces together tightly.
Leave this adhesive liner in
place until later step, for
final adjustments of mount.
Remove the adhesive liner.
Firmly press adhesive side
to face of mounting foot.
5
ASSEMBLE RAIL NUTS
5.1
5.2