16. Rotating brush
17. Window squeegee
18. Round bristle brush – large
19. Round bristle brush – small
20. Power jet tip – angled
21. Floor scrub brush adapter
22. Small tip adapter
23. Floor scrub brush cleaning cloth
Accessories
Technical characteristics
Steam compartment........... Stainless steel
Temp. MAX ......................... 170°C
MAX pressure ..................... 5 bar
Water tank .......................... 1,8L
Power consumption ........... 2000W
Voltage ............................... 220-240V
Frequency .......................... 50 Hz
Net weight {empty) ........... 3.6 kg
Filling
Before filling the steam cleaner with water, turn off
and unplug it. Make sure there is no more steam
by unlocking the steam trigger int the “on” position.
Always cool steam cleaner for 10 minutes before
adding water.
Note:
The filler cap will not unscrew without
pressure reduction.
1. Remove the filler cap by turning
counterclockwise.
2. Fill the water tank using the
funnel and measuring cup provided.
The maximum capacity of the tank
is 1.8L. Tip: Do not overfill the tank.
3. Replace the filler cap by tur-
ning clockwise until a good seal is
achieved.
Caution
If the filler cap is opened too quickly, without taking
the necessary precautions, there is a very high risk
of injury. The metal parts can be extremely hot;
avoid contact with the skin. Risk of burns.
1. Handle Operation.
Locate the Steam Release Trigger (2) and Trigger
Lock (3) on the Steam Handle (1 ). The Lock has
two positions, OFF/LOCK, and ON. Press the front
of the Trigger Lock to lock (A), press the back of
the Trigger Lock to unlock (B).
2. Releasing Steam.
When the Pressure Gauge (6) enters the red zone,
your HiSteam is ready to go (maximum pressure=
65 PSI). Press Green Trigger Lock (3) to the ON
position (B) and pull the Steam Release Trigger (C)
to release a burst of steam. Release trigger to stop
steam.
3. After use.
Lock trigger in OFF position to prevent accidental
operation. With trigger in open position, depress
Trigger Lock switch(3)
