Installa on
and
Opera ng
Manual
Page
5
INSTALLATION
Assembly kit:
DOOR GASKET NOT SEALING
Once the cabinet has been unpacked, you will notice that the top of the door may not be parallel with the
control panel above, and the door sealing gasket may not fit to the cabinet - see images below.
This situation arises due to the weight of the door pulling down on one side of the cabinet. To
demonstrate the correct position of the cabinet as if it were fixed to the wall, place two hands on the top of
the cabinet and slightly twist the unit. You will observe that an even gap is achieved between the top of
the door and the control panel. The sealing gasket should then make contact with the front edge of the
cabinet.
NOTE.
This drying cabinet is designed to be fixed to a solid wall or structure to ensure that it
is rigid and able to maintain its form. The cabinet should be located on a solid floor and the
feet adjusted to ensure that it is level and upright before fixing back to the wall. It is not a free
standing appliance.
