Installa on
and
Opera ng
Manual
Page
14
CARE
SERVICE AND REPLACEMENTS PARTS
If the connecting cable is damaged for any
reason, it must be replaced immediately.
All genuine parts can be obtained from the drying
cabinet dealer.
NOTE.
A replacement lead may only be
installed by the manufacturer, the
manufacturer’s service agent, or another
authorised electrician.
TROUBLESHOOTING
Problem
What you can do
The fan does not operate and
the cabinet is not heating up:
Check that the cabinet is connected to the power supply and that
the fuses are intact.
The drying cabinet is not
heating although the power
supply to the unit is confirmed:
If the green power indicator is not illuminated then the overheat
thermostat may have tripped out. Switch off the mains power
supply to the cabinet, leave for 20 minutes, and then restore the
power supply. Press the
ON/OFF
button several times to assess
whether the power has been restored (indicated by the green light).
Resonance or vibration occurs
when the fan is running:
Check that the cabinet is level in both planes and is securely fixed
to the wall. If the problem persists, try adjusting the feet ensuring
they are all in contact with the floor. See page 7 of this manual for
instructions.
The door switch is not working:
Figure shows an even gap between the
control panel and the top of the door.
To test the switch, select a drying programme, close the door, and
press
START/STOP
. If the display shows “CLOSE DOOR”, open
the door and manually press the switch with your finger - the switch
is found directly beneath the control panel, to the right-hand side. If
the drying programme resumes, the door switch is functioning
properly.
Check that an even gap exists between the control panel and the
top of the door. If they are not aligned properly, this may not
activate the switch. To rectify, ensure the cabinet is level and adjust
the feet and/ or door if necessary (see page 6 of this manual).
WARNING!
Isolate the electrical supply and
remove the power plug before withdrawing
the service control unit.
In the event of further or persistent problems, please contact your dealer.
The service module can be removed from the
cabinet to enable any repairs or maintenance
work to be carried out.
You
MUST first disconnect the cabinet from
the power source
, then open the door before
removing the four screws underneath the control
panel. Carefully pull the service module out.
1. Service
module
2. 4 x Torx screws
