ECP
300
EXPERT STEPPER
Page
13
OPERATION AND MAINTENANCE MANUAL
Rev. 01-20
FRONT PANEL CONNECTION
Now reattach the front piece and reconnect the electronic board connector as shown
below.
Fig.12:
Reattach the front piece to the bottom
of the case by reinserting the two
hinges in the appropriate seats.
Fig.13:
Bend the hinges and rotate the front
180° downwards to access the inside
of the panel and reconnect the
connector of the electronic board.
Fig.14:
If the panel is connected to a
TeleNET/Modbus
network and/or the
Aux/Alarm relay is used, make the
necessary connections directly on the
terminals of the electronic board.
As a cable path for these connections,
it is recommended to place the existing
connection cord between the electronic
board and the bottom of the panel.
For
further
clarification
on
the
connection terminals refer to chapter
6.1.
3.4
CHAP. 3 - Installation