Peg-Perego Viaggio 2-3 Shuttle Plus, Instructions For Use Manual

Page: 29 / 176

- 29 -
proceed to remove the seat.
11
• To reposition the connectors
within the seat, pull the lever (1) while
pushing one of the two connectors (2)
until they are barely visible.
How to attach the car seat
to the vehicle
if you own a car with no
Isofix attachments
12 • Position the Viaggio 2-3 Shuttle
Plus car seat on the vehicle seat in
the direction of travel, leaving the
attachments inside the Surefix Base
(fig_a) and position the child in the
seat as shown in the figure (fig_b),
ensuring the car seat does not move
during this operation.
How to secure your child
with Viaggio 2-3 Shuttle Plus
13 • Fasten the seat belt, ensuring that
it clicks into place. Position the two
parts of the seat belt as shown in
figure; both the waist and shoulder
straps must pass under the armrest.
14
• To finish securing your child, thread
the belt through the router placed on
the headrest: thread the belt between
the router and the headrest (1) until it
slides into the router slot (2).
IMPORTANT: If the belt is loose,
pull it taut above the loop (3).
Ensure the belt is always tensioned
and untwisted.
15
• To remove the belt, slide it out of
the router slot (1) and then between
the router and the headrest (2) until it
is completely removed.
16
•
IMPORTANT:
the seat belt
is correctly positioned if the child’s
shoulders are slightly below the seat
belt loop, as shown in the figure.
Use without backrest
WARNING: Do not use Viaggio
2-3 Shuttle Plus without the
backrest if your child is less than 125
cm tall.
HOW TO REMOVE THE BACKREST
17• Pull the carry handle bar (1) to
permit access to the two buttons on
the back.
Press the two buttons (2) while
simultaneously pulling the backrest
upwards (3).
18•
insert the two hooks on the seat
into their housings adjacent to the
back part of the seat.
How to connect up the
car seat in the car if you
have a car with Isofix
connectors
Refer to the figures and text from
point 6 through point 11.
How to connect up the
car seat for cars that are
NOT fitted with Isofix
connectors
Refer to figure 12 and the
corresponding instructions.