7 of 42
ISSUED: 12-01-09 SHEET #: 095-9295-2 01-23-10
For Flat Back Screen
For Bump-out or Recessed Back Screen
2-1
Begin with the shortest length screw, hand thread through washer, adapter bracket and spacer, if required, into
screen as shown below. If screw cannot make three full turns into the screen and fit snug into place, select a
longer length screw from the baffled fastener pack. Repeat for remaining mounting holes, level brackets and
tighten screws.
NOTE:
Spacers may not be used, depending upon the type of screen.
NOTE:
If screen manufacturer's requirements state that more than 1.1" of ventilation is required, spacers may be
used to add an additional 0.75" of space between the wall and the screen as shown below.
Begin with the shortest length screw, hand thread through washer, adapter bracket and spacer, if required, into
screen as shown below. If screw cannot make three full turns into the screen and fit snug into place, select a
longer length screw from the baffled fastener pack. Repeat for remaining mounting holes, level brackets and
tighten screws.
WASHER
ADAPTER BRACKET (
B
)
SCREEN
SCREW
SCREEN
SCREW
ADAPTER BRACKET (
B
)
SPACER
WASHER
If you have any questions, please call Peerless customer care at
1-800-865-2112
.
If you have any questions, please call Peerless customer care at
1-800-865-2112
.
SCREEN
SCREW
ADAPTER BRACKET (
B
)
SPACER
WASHER
2-2
