7 of 27
ISSUED: 05-17-07 SHEET #: 202-9208-3 5-7-08
Visit the Peerless Web Site at www.peerlessmounts.com
For customer care call 1-800-865-2112 or 708-865-8870.
2
fig. 2.1
NOTE:
"X" dimensions should be equal.
Notes:
• Always use multi-washers when attaching
vertical brackets (
B
) to your screen.
• Use the corresponding hole in the multi-
washer that matches your screw size as
shown in figure 2.2.
• Spacers may not be used, depending upon
the type of screen.
• Tighten screws so adapter brackets are firmly attached. Do not tighten with excessive force. Overtightening can cause
stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become
detached.
Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to screen or product may fail.
WARNING
Installing Vertical Brackets
CENTER BRACKETS
VERTICALLY ON BACK OF
SCREEN
To prevent scratching the screen, set a cloth on a flat, level surface that will support the weight of the screen. Place
screen face side down. If screen has knobs on the back, remove them to allow the adapter brackets to be attached.
Place vertical brackets (
B
) on back of screen. Align to holes, and center on back of screen as shown in figure 2.1.
Attach the vertical brackets to the back of the screen using the appropriate combination of screws, multi-washers, and
spacers as shown in figure 2.3.
NOTE:
Be sure to attach vertical brackets with wall support brackets positioned at the
bottom of screen as shown in figure 2.1.
NOTE:
Top and bottom mounting holes must be used for attaching brackets. Middle holes should also be used where
the fasteners and screens allow.
Verify that all holes are properly aligned, and then tighten screws using a phillips screwdriver.
MEDIUM HOLE FOR M5 SCREWS
SMALL HOLE FOR M4 SCREWS
LARGE HOLE FOR M6 SCREWS
fig. 2.2
MULTI-WASHER
X
X
WALL
SUPPORT
BRACKETS
NOTE:
For
flat back screens
proceed to step 2-3. For
bump-out or recessed back screen
skip to step 2-4
