4 of 42
ISSUED: 09-10-09 SHEET #: 202-9367-7 04-05-11
Installation to Double-Stud Wood Wall
Use a stud fi nder to locate the edges of the studs and draw a vertical line down each stud’s center. Place wall
plate on wall as a template. The top mounting slots should be located 1.88" (48mm) above the desired display
center as shown in fi gure 1.1. Level wall plate, and mark the center of the four mounting holes. Make sure that the
mounting holes are on the stud centerlines. Drill four 5/32" (4mm) dia. holes to a depth of 2" (51mm). Make sure
that the wall plate (
A
) is level and secure wall plate using four wood screws (
C
) as shown in fi g. 1.2.
• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
• Tighten wood screws so that wall plate is fi rmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud fi nder
is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Install-
ers are responsible to provide hardware for other types of mounting situations. (not evaluated by UL)
WARNING
C
A
fi g. 1.2
fi g. 1.1
CD=CENTER OF DISPLAY
CD
A
STUD
1.88"
(48Mm)
1