5 of 18
ISSUED: 03-25-09 SHEET #: 202-9334-1
Installation to Triple Wood Stud Wall
Wall plate (
AA
) can be mounted to three studs that are 16" apart. Use a stud finder to locate the edges of the studs.
Use of an edge-to-edge stud finder is highly recommended. Based on their edges, draw a vertical line down each
stud’s center. Place wall plate on wall as a template. The top mounting slots should be 2.5" (64 mm) above the
desired screen center as shown in figure 1.1. Level plate, and mark the center of the six mounting holes. Make sure
that the mounting holes are on the stud centerlines. Drill six 5/32" (4 mm) dia. holes 2.5" (64 mm) deep. Make sure
that the wall plate is level, secure it using six #14 x 63.5 mm wood screws (
DD
) as shown in figure 1.2.
Skip to step 2.
NOTE:
Wall plate may be mounted up to 6" (152 mm) off center as shown in figure 1.1.
DD
AA
fig. 1.2
1
• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
• Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder
is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Install-
ers are responsible to provide hardware for other types of mounting situations (not UL approved).
WARNING
CS = center of screen
fig. 1.1
STUD
AA
6"
(152 mm)
2.5"
(64 mm)
6"
(152 mm)
CS
