8 of 10
ISSUED: 09-30-11 SHEET #: 009-9056-5 (2014-04-08)
Begin with the shortest length screw, hand thread through multi-washer and adapter bracket into display as
shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not
over tighten. If screw cannot make three full turns into the display, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE:
Spacers may not be used, depending upon the type of display.
Begin with longer length screw, hand thread through multi-washer, adapter bracket and spacer in that order into
display as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place.
Do not over tighten. If screw cannot make three full turns into the display, select a longer length screw from the
baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
For Flat Back Display
For Bump-out or Recessed Back Display
8-1
8-2
If you have any questions, please call Peerless customer care at
1-800-865-2112
.
If you have any questions, please call Peerless customer care at
1-800-865-2112
.
DISPLAY
MULTI-WASHER
SCREW
ADAPTER
BRACKET (
F
)
fi g. 8.2
SPACER
ADAPTER
BRACKET (
F
)
DISPLAY
fi g. 8.1
MULTI-WASHER
SCREW
