Visit the Peerless Web Site at www.peerlessmounts.com
ISSUED: 03-23-09 SHEET #:055-9260-5 09-26-12
5 of 9
Note:
For PSTK-028 models, refer to page 6.
Drill four 5/16" (8 mm) dia. holes to a minimum
depth of 2.5" (64 mm). Insert anchors (
G
) in
holes fl ush with wall as shown. Attach wall arm
(
A
) using four #14 x 2 -1/2" wood screws (
E
) as
shown in
Illustration A
and
1
,
2
, and
3
. Tighten
all fasteners.
Optional:
Rotate wall arm 180° to
position the arm closer to the ceiling.
Skip to Step 2.
1
E
G
Illustration A
A
Installation to Solid Concrete or Cinder Block Wall
for PSTA-028, PSTA-028-W Models
• Tighten wood screws fi rmly, but do not overtighten.
Overtightening can damage the screws, greatly
reducing their holding power.
• Never tighten in excess of 80 in • lb (9 N.M.).
WARNING
• Concrete anchors are
not
intended for attachment to
concrete wall covered with a layer of plaster, drywall,
or other fi nishing material. If mounting to concrete
wall covered with plaster/drywall is unavoidable (not
evaluated by UL), plaster/drywall (up to 5/8" thick)
must be counterbored as shown right. If plaster/
drywall is thicker than 5/8", custom fasteners must
be supplied by installer (not evaluated by UL).
WARNING
CUT
A
W
A
Y
VIEW
INCORRECT
CORRECT
wall
plate
wall
plate
plaster/
dry wall
plaster/
dry wall
concrete
concrete
WARNING
• When installing Peerless wall mounts on cinder block, verify that you have a minimum of 1-3/8" of actual concrete
surface in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount in a
solid part of the block, generally 1" minimum from the side of the block. Cinder block must meet ASTM C-90
specifi cations. It is suggested that a standard electric drill on slow setting is used to drill the hole instead of a
hammer drill to avoid breaking out the back of the hole when entering a void or cavity.
• Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.
• Make sure that the wall will safely support four times the combined load of the equipment and all attached hardware
and components.
1
3
G
Drill holes and insert anchors (
G
).
Place plate (
A
) over anchors (
G
) and secure with screws (
E
).
Tighten all fasteners.
2
G
A
E
concrete
surface
SOLID CONCRETE
CINDER
BLOCK
