10 of 24
ISSUED: 11-07-13 SHEET #: 180-9044-1
Step 3
The broadcaster needs to be as centrally located as possible to allow its’ omni-directional antenna
uniform coverage over the entire area that the DTV’s will be located within. Install the Broadcaster as
high in the air as possible to ensure that an unimpeded signal is transmitted down toward the DTV’s.
Proper positioning will allow the full radial distance potential of 350’ (106m).
The Broadcaster can be mounted to a vertical surface if required. The rubber pads on the bottom of
the Broadcaster may be removed prior to installation. Ideally, the Broadcaster should be installed in
one of the orientations pictured below (mounting hardware not included).
Note:
To ensure uniform
signal coverage, the antenna must point straight up.
Step 4
The Broadcaster will need to access the internet and receive its media content via a network
connection. Connect the broadcaster to the network before applying power to the device. Plug in
the power adapter into an available power outlet.
Note:
If the broadcaster becomes unplugged from
its power adapter, wait 30 seconds before applying power to allow it to reset.
The diagram below shows two typical Broadcaster installations.
PC/Media Player
Internet
Ethernet Switch
2-way Splitter
4-way Splitter
4-way Splitter
HDS-PB100
HDS-PB100
RX
Antenna
RX
Antenna
Standard
Coaxial
