24
8. ALARMS
Alarm!
DRY
RUNNING
MOTOR
The cos-fi value detected is lower than the one programmed.
The display flashes and the alarm output is enabled (clean NC-C-
NA contacts).
The system is automatically reset according to the time set while
it was being programmed.
Alarm! MOTOR
PROTECTED
The current absorbed by the load exceeds the value program-
med.
The display flashes and the alarm output is enabled (clean NC-C-
NA contacts). The system can be automatically reset by pushing
the
pushbutton.
Alarm!
VOLTAGE
TOO
LOW
The voltage of the electrical power system detected is too low.
The display flashes and the alarm output is enabled (clean NC-C-
NA contacts).The system is to be reset manually by pushing the
pushbutton.
Alarm! VOLTAGE TOO
HIGH
The voltage of the electrical power system detected is too high.
The display flashes and the alarm output is enabled (clean NC-C-
NA contacts).The system is to be reset manually by pushing the
pushbutton.
Alarm! SEQUENCE OR
MISSING PHASE
The sequence of the phases detected is not correct or one or
more phases are not present.
The display flashes and the alarm output is enabled (clean NC-C-
NA contacts). The system resets automatically by turning off and
on the electrical panel.
