MN-36956/MM-1074
Rev 0 (01/15) • Blanket Warming Cabinet Operation & Care Manual • 17
C A U T I O N
DO NOT OVERLOAD CABINET.
Allow 1" (25mm) gap between
blankets and interior of cavity or shelf.
C A U T I O N
Blanket support inserts must be
used when warmer is in use.
1 .
The appliance should be plugged into an appropriate hospital grade
receptacle as specifi ed on the electrical information page.
2 .
TURN ON THE POWER SWITCH
, which is located at the back or side of the
appliance just above power cord .
3 .
ACTIVATE CONTROL BY PRESSING THE ON/OFF BUTTON ON
CONTROL PANEL ONCE.
4 .
SET DESIRED TEMPERATURE.
To set the blanket warming temperature, press and hold the UP or
DOWN ARROW keys to change the value shown in the display . The
temperature set-point range is 32 - 71°C (90 - 160°F) .
5 .
LOAD THE CHAMBER WITH DRY, COTTON BLANKETS. DO NOT WARM
ITEMS CONTAINING PLASTIC, RUBBER OR METAL SNAPS, STUDS,
HOOKS, ETC.
Check that the epoxy-coated blanket insert is in place . This
blanket insert MUST be used to hold blankets when unit is in use . Make
certain the cabinet door is securely closed during use .
6 .
ROTATE LOAD OF BLANKETS DAILY.
Rotate the blankets at the bottom of the load to the top to ensure equal usage .
Failure to rotate blankets can cause blankets to discolor .
Note: Avoid using fl ammable cabinet cleaning agents, as well as blanket
cleaning agents that cause fabric to become brittle over time.
FU-34955
F2 FUSE
FU-34955
F1 FUSE
FUSE COMPARTMENT DOOR
FUSE DRAWER
B L A N K E T C H A M B E R O P E R A T I O N P R O C E D U R E S