2-7 Exhaust Diverter Installation
Insert the exhaust deflector P#(J0251) onto the end of
the muffler. Orientate the exhaust diverter to exhaust
towards the rear of the mower. The diverter is used to
keep the engine exhaust from burning the cloth bags,
and the PTO or engine/blower/blade assembly. Secure
the exhaust diverter with (1) exhaust clamp kit
P#(X1046). Refer to Figure 2-7.
2-8 PTO Mount Assembly Installation
PTO MODELS ONLY
NOTE:
Continue to Section 2-13 on page 10 if you
are installing an engine driven unit.
Secure the PTO mount plate assembly P#(A1825) to the
rear bumper of the mower using (4) 3/8”-16 x 1” HHCS
P#(K1191) and (4) 3/8”-16 nylon flange locknuts
P#(K2038). Refer to Figure 2-8a.
On all engine models with an engine oil drain hose on
the right side of the engine, attach the existing J-hook to
the rear bumper using the PTO mount assembly
hardware shown in Figure 2-8b.
2-9 PTO Assembly Installation
PTO MODELS ONLY
Insert the PTO assembly P#(A0623) into the PTO mount
plate assembly as shown in Figure 2-9a. The mount rod
on the PTO assembly slides into the mounting slots on
the PTO mount plate assembly. Secure the PTO
assembly with (1) mount pin P#(B0274) and (1) hair pin
clip P#(K0086) shown in Figure 2-9b. Remove the pulley
guard in preparation for the belt installation.
8
Figure 2-8a
(4) 3/8”-16 x 1” HHCS
(4) 3/8”-16 Nut
PTO Mount
Plate Assembly
Rear
Bumper
Figure 2-8b
Existing
Hardware
Engine Oil
Drain
J-Hook
Figure 2-7
Exhaust
Clamp Kit
Exhaust
Diverter
Figure 2-9b
Mount Pin
Hair Pin
Clip
Figure 2-9a
PTO
Assembly
Mount
Rod
Remove Pulley
Guard
