– 13 –
xv. TROUBLESHOOTING
Problem
Possible Cause
Solution
Machine does not run when
switched on.
Power cord not properly
fixed/plugged in.
Check that the machine is properly
connected to the power supply.
Motor stops (power cut out).
Too much pressure exerted
while cutting.
Exert less pressure when cutting.
Poor machine performance little
power.
Power cord/extension cable too
long or cable still wound up
inside cable drum.
Use a power cord/extension cable of
the rated length, use a cable drum
with a cable fully extended.
Incorrect specification for saw
blade.
Use a saw blade which corresponds
to the material being cut.
Saw has a defective electric
system.
Have the electric system of the saw
checked by a qualified technician.
Power cord defective.
Have the power cord checked,
replaced if necessary.
Main power switch defective.
Have the main power switch checked
and replaced if necessary by a
qualified electrician.
Loose electrical connection
inside the electric system.
Have the whole electric system of the
machine checked by a qualified
electrician.
Motor defective.
Have the motor checked and replaced
if necessary by a qualified technician.
Power network is insufficient.
Observe the electric ratings of the
machine and connect it only to a
power network which complies with
these ratings.
Drive motor no longer runs at
rated speed (r.p.m.).
Have the motor checked by a
qualified electrician and have it
replaced if necessary.
For your safety and the safety of others, turn the power switch off and always remove the
plug from power source before troubleshooting. Repairs performed by unauthorized
personnel could cause serious hazard. We recommend that service to this tool be performed by a qualified service
technician with original equipment replacement parts.
WARNING!
