– 12 –
xiii. ELECTRICAL MOTOR SPECIFICATIONS
Horsepower
3 HP
Volts
115V/230V
Amps
15A
Motor RPM
3,600 rpm
Cycle
60 Hz
Watts
2238
Length of Cord
3 HP - 115 V
25'
50'
75'
Recommendations:
• It is recommended that a
15 amp circuit
be used while operating this saw.
This will prevent possible power interruption or loss.
• Always plug saw as close as possible to the power source while operating.
This will allow you to receive optimum electricity.
Electrical Wiring Diagram
WARNING: To avoid
permanent motor damage you
must use the correct extension
cord. Never use more than one
extension cord at a time. Follow
the chart for proper size.
WIRE
GAUGE
No. 10
No. 8
No. 6
xiv. WATER HOSE KIT INSTALLATION
1.
Orient the water pipes as shown in Fig. A. Insert the
shortest pipe from the "Y" adapter into the adjacent
sleeve at the rear of the blade guard. First, you will need
to remove the black cap covering the hole insert (#1).
The longest pipe, which has a control valve midway,
should be pointed towards the floor. Secure the "Y"
adapter to the rear of the blade guard using the provided
bracket and screws.
2.
Insert the second pipe protruding from the top of
the "Y" adapter into the slot located on the side of
the blade guard towards the front of the saw. This
is the hole in the front of the blade guard (#2), do
not remove the black caps on the side. See Fig. B.
#1
#2
Black caps
(do not
remove)
Some force will be required to
pinch the mouth of the pipe
when inserting it into the slot.
Fig. A
Fig. B
