6.5. REL Relative Measurement
The relative measurement feature lets you measure values relative to a reference value and then
measure the difference between the actual value and the reference value.
Follow the steps to set a reference value:
1. Take a reading of your reference value
2. Press the REL-button to activate the REL-Mode, REL appears on the display
3. The measured reference value will be shown in the left secondary display
4. Take your further measurements and see the differences between the reference and the actual
values in the primary display.
6.6. MEM - Memory
Follow these steps to store up to ten measured values in memory for later recall:
The DMM provides 30 internal memories.
Follow these steps to save a measured value:
1.
Choose the needed measuring function.
2.
Make the measurement until the measured value is displayed on the display.
3.
Press MEM-button to save the actual value to the next free memory place.
The display shows the memory place, where the value will be saved. (0 to 30).
4.
To delete the complete memory (0-30), release the MEM-function by pressing MEM-button,
then press the CLEAR-button for 2 seconds.
Note:
If you store a reading into a memory location, which already has stored a data, the old data will be
updated with the new value.
6.7. RCL Memory Recall
Follow these steps to recall a measured value from one of the 30 memories.
1.
Press View-button.
In the display appears the next free memory.
1.
Press View
or View
to recall the needed memory place, the saved value will be shown
next.
3. To release the recall function, press MEM-button.
-32-
