7.11. Stop Test
To stop the test in progress, press the TEST-button (1). The test
will immediately stop and the instrument will enable the ENER-
SAVE
TM
mode automatically.
7.12. Auto-Stop
Should the operator leave the instrument in the test mode with
the ENER-SAVE
TM
disabled, the instrument will automatically
stop the test after a duration of 99.9 seconds (Auto-off still
applies).
7.13. Auto live / voltage warning
Should the leads be placed onto a live system before starting the
test, a warning beeper will be automatically activated and the
instrument will display "Live Warning ... Circuit Live .... "
Message. Immediately disconnect the instrument from the circuit
and discharge the circuit (in the case of capacitive system) or
make sure, that the circuit under test is not live.
7.14. Auto-discharge
At auto-stop or test completion, the instrument automatically
discharges the system under insulation test, so that the
dangerous high voltage is discharged.
The auto- discharge can be observed on the L.C.D. so that the
operator only removes the leads when the discharge is complete.
During discharge, a beep occurs so that the user waits for the
complete discharge of the system under test.
-31-
