TO ADJUST THE SPRING TENSION:
1. While holding the Spring Adjustment Slider cylinder with your left hand, pull the Pull Pin
with your right.
2. Slide the cylinder to the desired location on the Foot Pedal vertical tube.
Note:
The num-
ber for the locating hole will appear directly above the top edge of the cylinder.
3. Let go of the Pin allowing it to engage the desired locating hole.
Warning: Be sure that the Pin fully engages the locating hole before beginning exercise.
Note: The two Spring Adjustment Sliders on the Split-Pedal model can be adjusted inde-
pendantly providing a greater variety of resistance levels.
Adjusting the spring position
TO ENGAGE SINGLE PEDAL MODE
(acts as a Single Pedal)
:
Note: “Right” and “Left” are defined as the user’s right or left when sitting on the Chair
with feet on the Foot Pedal.
1. Make sure that the two exercise springs are adjusted to the same postiion 1, 2, 3, or 4.
2.
Completely
withdraw the gray knob located on the left side of the Foot Pedal.
3. Rotate Clockwise (when facing the knob) as far as possible and release the knob.
Caution: Verify that the pin connecting the 2 halves of the Split-Pedal is fully engaged
before beginning exercise.
TO DISENGAGE SINGLE PEDAL MODE
(Split-Pedal mode)
:
1.
Completely
withdraw the gray knob located on the left side of the Foot Pedal.
2. Rotate counterclockwise (when facing the knob) as far as possible and release knob.
Caution: Verify that the pin connecting the 2 halves of the Split-Pedal is fully retracted
into the left side of the Foot Pedal before before beginning exercise.
User Guide
