12
casa reformer owner’s manual
WORKING WITH THE SPRINGS AND ADJUSTMENTS
The casa reformer comes with 5 springs of different
resistance levels as shown.
RED - heavy. One center spring
YELLOW - medium. Two middle springs
BLUE - light. Two outside springs
To attach a spring to an eye bolt on the gear bar,
lift the end of the spring and insert the spring hook
through the respective eye bolt on the gear bar.
WARNING
AT LEAST ONE SPRING MUST BE ATTACHED TO THE GEAR BAR AT ALL TIMES EXCEPT
DURING GEAR BAR ADJUSTMENTS. MAKE SURE THAT THE GEAR BAR IS FULLY ENGAGED
IN ONE OF THE FOUR POSITIONS BEFORE ATTACHING A SPRING OR BEGINNING AN
EXERCISE. INSURE THAT THE GEAR BLOCK IS LOCATED IN THE CORRESPONDING
NUMBERED POSITION. FAILURE TO DO SO COULD RESULT IN INJURY TO THE USER
OR DAMAGE TO THE REFORMER.
GEAR BAR AND GEAR BLOCK ADJUSTMENTS
The gear bar and gear block positioning allow for the adjustment of movement of the carriage for different body sizes and
different exercises. The gear bar and gear block should
always be adjusted together and should always be located in the same
corresponding numbered position. There are 4 positions for the gear bar and gear block; -1, 1, 2 and 3.
TO ADJUST THE GEAR BAR
:
TO ADJUST THE GEAR BLOCK:
l
Remove all of the springs from the gear bar
l
Lift the center of the gear bar up and out of the position
l
Slide the bar forward or backward to the desired position
l
Make sure that the gear bar falls into the slot and is fully engaged
l
Pull out the gear block and place it in
the corresponding gear bar position
l
Make sure that the block is pushed all
the way into the hole
1
PEAK-CASA-OM-2020.indd 12
PEAK-CASA-OM-2020.indd 12
4/16/20 8:23 PM
4/16/20 8:23 PM
