10
casa reformer owner’s manual
ATTACH THE SPRINGS
ASSEMBLE THE SHOULDER PADS
INSTALL THE RISERS
Attach the reformer springs to the anchor bar on the
underside of the carriage. The open part of the hook
should be facing away from the carriage (down).
Install the springs by color as shown.
Remove the shipping spacers located between the
frame of the carriage and the aluminum rails.
With two people holding the reformer, turn the unit
over onto its legs.
Place the shoulder blocks into position, aligning the
mounting holes. Secure using Flat Head Socket Screws.
Partially tighten all four screws. Once all four are
partially tightened, go back and fully tighten
with the provided 5mm allen wrench.
Align the fixed riser on the inside of the reformer
to the holes on the head end panel. Hand thread
the flat head screws from the outside in to the riser.
Go back and fully tighten the screws. Install the
second riser the same way.
flat head socket screws
4 per shoulder block
flat head socket screws
2 per riser
anchor bar
7
8
9
10
11
PEAK-CASA-OM-2020.indd 10
PEAK-CASA-OM-2020.indd 10
4/16/20 8:23 PM
4/16/20 8:23 PM
