PD Technology BigBot, Assembly Instructions Manual, Page: 43 / 61

4.10 EXTRUDER ASSEMBLY (1 OR 2)
PART LOCATION QTY
[1] HS MOUNT, L &R PLASTIC PARTS BAG 1
[2] EXTRUDER MOTOR L & R EXTRUDER BOX 2
[3] DRIVE GEAR HARDWARE BOX 1
[4] LEVER L & R EXTRUDER BOX 1EA
[5] HEATSINK CLAMP L & R EXTRUDER BOX 1EA
[6] HEAT BREAK L & R EXTRUDER BOX 1EA
[7] TEFLON TUBE L & R EXTRUDER BOX 1EA
[8] CLAMP SCREWS BAG 46 2EA
[9] CLAMP NUTS BAG 34 2EA
[10] FLAT SCREW BAG 41 1EA
[11] FLAT SCREW BAG 44 2EA
[12] LEVER SPRING L & R EXTRUDER BOX 1EA
[13] LEVER V BEARING L & R EXTRUDER BOX 1EA
[14] LEVER PIN SCREW BAG 42 1EA
[15] SCREW BAG 43 1EA
[16] 30mm FAN ASM 5.8 1EA
[17] HEATSINK L & R EXTRUDER BOX 1EA
[18] HOT END L & R EXTRUDER BOX 1EA
[19] NOZZLE L & R EXTRUDER BOX 1EA
NOTE HOT END
ORIENTATION
LEFT
EXTRUDER
RIGHT
EXTRUDER
2. THREAD HEAT BREAK
FULLY INTO HEATSINK
3. INSERT PTFE TUBE
FULLY INTO HEAT BREAK
4. THREAD NOZZLE FULLY
INTO HOT END, THEN
LOOSEN 1/2 A REVOLUTION
5. THREAD HOT END ONTO
HEAT BREAK UNTIL
HEAT BREAK STOPS
AGAINST NOZZLE TOP
1. INSERT HEATSINK
INTO MOUNT
[3] ALIGN WITH FILAMENT HOLE
[2]
[9]
[1]
[10]
[11]
[4]
[12]
[14]
[13]
[15]
[5]
[17]
[8]
[16]
[6]
[7]
[18]
[19]