PINO E - Building Instruction
July 2017
www.pcm.at
6
Prepare the parts for gluing
the control levers into the
wing.
Grind all gluing
surfaces
, the slot of the
control surfaces and the
levers themselves.
The
bolt
of the
lever
connector
has sharp edges
that are bigger than the bolt
diameter. You should
remove these edges
, before
you put the connector into
the lever. It is easy to clean
that bolt with nose pliers.
Grab the bolt with the nose
pliers and move the
connector up and down
about 3 times as shown in
the picture. Repeat this that
often until the connector is
able to
move in the lever
hole without a lot of
friction
.
Before you glue the lever into the control surface,
fix the
connector
to the lever
.
You can use
runny super glue
to fix the levers. This kind of
bonding will be strong enough for the forces occurring.
Cable mounting:
Mill a hole
into the preformed space for the contacts. Make the
hole big enough, so that the
contacts will not touch the
carbon
.
