Administrator: Load Default Setting to EEPROM
Clicking the
Load
button will make the switch being set to the
original configuration.
※
Note: It exclude to change user name, password and IP
configuration. If you want to restore default setting including
IP and user name password, then you can press the reset
button for hardware base reset.
More detail information about Load Default Setting - Hardware
Base is described as following.
The purpose of this function is to provide a method for the network
administrator to restore all configurations to the default value.
(1) To activate this function, the user should follow the following
procedures. Press the “Load default” button for 3 seconds until
you see the LED blinking.
(2) When LED starts blinking, it means the CPU is executing the
“load default” procedure. You can release the button now.
After completing this procedure, all the factory default value
will be restored. It includes the IP address, the user name, the
password and all switch configurations.
