e. Memory
e-1. Location
The gauge has a memory capacity of 4000 measurements which location can be from 0000 to 3999. After
taking every measurement, press
key to store the value with a location number. You can also select an
initial number for beginning to store the value and the next number will be followed automatically by following
measurements.
- Press
key into“ Location ”state
- Press
or
to select desired number as initial location
- Press
key to enter/confirm
If you want to read the stored value in memory,
Press
key to read one by one data according to the above procedure, select desired initial number. Then
the desired group of value can be readable beginning from this initial number.
e-2. Delete Memory
Delete the data in memory which locations are selected.
f. Limitation
- Press
key into“ Limitation ”state
- Press
or
to select desired low limitation and high limitation
- Press
key to enter/confirm
When the measuring value is lower or higher than the limit value a sign “L” or “H” will appear on the right top of
LCD.
g. Average Measurement
You can get mean values by 2 to 9 times on TG 200 thickness gauge
- Press
key into “ Average ”state
- Press
to select desired average times (2 to 9)
- Press
key to enter/confirm
When complete measuring once, you must wait about 3 seconds, the gauge will calculate measuring data and
average times will decrease 1 appearing on the right top of LCD. When average times is zero, the gauge will
show the averaged value on LCD.
h. Print Out
If you want to print the stored values, you must determent the initial location number and the end location
number,
- Press
key into “Print” state
- Press
or
to select desired initial and end location number.
- Press
key to enter / confirm
The gauge will print the stored value in memory from initial location number to end location number
automatically.
