Manual
8
5 Operation
5.1 Turn on the device
1. Make sure the battery is installed or the device is connected to an external power source.
2. Put the device on the supplied calibration cover (for more information see chapter 5.3.2
“Calibration”).
3. Turn on the device by pressing the power button. After a few seconds, you are automatically
directed to the “Standard Measurement” screen. The default setting for this measuring mode is
L*a*b*C*h.
5.2 Take a measurement
When
you turn on the device, you are directed to the “Standard Measurement” screen. To take a
measurement, follow these steps:
1. Press and hold the testing button. A light cone will then appear to help you aim at the measuring
point.
2. Move the device as close to the measuring point as possible.
3. Release the testing button. The colour meter now takes a measurement.
Alternatively, you can also press the Up button
. This activates the integrated camera. You can
now see the position of the measuring hole on the display. Once you are done with positioning, just
press the testing button.
After the measuring procedure is finished, you can see the results on the following screen:
