PCE Instruments PCE-BS 300, Manual

Page: 4 / 6

4
3. PREPARATION
1. Installing batteries/Connecting the AC adaptor
Batteries
Battery Remove the battery compartment
compartment cover and insert six batteries(R6P/LR6
/AAsize) into the battery compartment,
taking
extreme care that the polarities
plus and minus is observed.
R6P/LR6/AA size dry batteries.
Battery compartment cover (batteries are not included)
AC adapter (optional)
Plug the AC adapter to the AC
AC adaptor adapter socket on the side.
socket The AC input requirement could
be 110,120,220,230 or 240Volts
(50/60Hz) depending on the area
where used, so please verify that
the adaptor is correct
2. Setting up the scale/balance
¡¡CAUTION!!
Avoid installing the scale/balance in direct sunlight that may cause discoloration or malfunctions. Place your
scale/balance on a firm weighing table so that the scale/balance is level. (The scale/balance will not perform
accurately when it is not level.)
Place the scale/balance on the firm surface that is flat and level for an accurate weighing.
1. Selection of auto backlight mode.
When the balance enter function setting menu. Press
[UNIT]
key, the display will show
L_ON
or
L_OFF
,
press
[ZERO]
, selection display L_ON, this means auto backlight function active, press
[ZERO]
again, the
display will show
L_OFF
, this means auto backlight function inactive, i.e. shut off backlight function.
2. Selection of auto shut off mode.
When the balance enter function setting menu. Press
[UNIT]
key, the display will show
A_ON
or
A_OFF
,
press
[ZERO]
, selection display A_ON, this means auto shut off function active. Press
[ZERO]
again, the
display will show
A_OFF
, this means auto shut off function inactive.
3. Return to weighing mode.
Press
[ON/OFF]
to turn the power off, press
[ON/OFF]
again to turn on the power and the scale return to the
weighing mode.
Counting procedures
1.Press [ON/OFF] to turn on the scale.
Wait for "0" to appear on the display.
2.Start the Count Procedure
If necessary, press
[ZERO]
key to set the display to “0”.