Address:East Room 306,3th Floor,1st Building,Shenhua Industrial Park,Meihua Road, Futian District,Shenzhen City
Tel:0755-32978297
Email:[email protected]
Manual
5. Measuring Procedure
5.1
Type K measurement
1. Start device by pressing “POWER” key
2. The standard thermal element of this device is the type K. Thus the display will indicate “K”.
The standard temperature unit is °C. How to switch to F or back, is described under 8.6
3. Plug the type K into one of the inputs. The device will now show the temperature values of
the first 8 channels (CH1, CH2, CH3, CH4, CH5, CH6, CH7, CH8)
4. To see the temperature values of the other 4 channels (CH9, CH10, CH11, CH12), press the
“PAGE” key. Thus the temperature values of the remaining channels will be indicated. To
turn back to the first eight channels, press “Page” button again.
5.2
Type J / T / E / R / S measurements
The measurement procedure is the same for every thermal element. To select the sensor type, press
“Type” button. The display will indicate the relevant type
.
5.3
Data Hold function
By pressing the “Hold” button, the last measured value will be frozen on the display. Exit the function
by pressing the button again.
5.4
Max. / Min. function
1. The temperature recorder offers the option to record the maximum (MAX) and minimum (MIN)
value of a series of measurements.
a. First briefly press the “REC” button. As soon as the recording mode is activated, the
display will indicate “REC”.
b. When the display indicates “REC”, the device will start recording the minimum and
maximum value.
2. The following recordings can be made when the display shows “REC”:
a. To measure the maximum value, the “REC” button must be pressed again. Now the
display will indicate “MAX” next to the “REC” symbol. Then the display will indicate
the highest recorded value since the “REC” symbol appeared on the display.
b. By pressing the button again, there will appear “MIN” next to “REC”. Thus the lowest
value since activating the “REC” mode will be recorded.
c. By pressing the “REC” key again for several seconds, you can exit the mode. The
values will be cleared then, as will be the symbol and the memory.
5.5
Background lights of Display
The background lights of the device can be turned on and off by pressing the “POWER” button whilst
the device is switched on. If the signaller is activated, the device will give signal noises when you turn
the background lights on and off.
.
6
