2: Mainboard Installation
Expansion Slots
This mainboard has one AGP, one CNR and five 32-bit PCI slots.
Follow the steps below to install an AGP/CNR/PCI expansion
card.
1. Locate the AGP, CNR or PCI slots on the mainboard.
2. Remove the slot cover for this slot from the system chassis.
3. Insert the expansion card edge connector into the slot and press
it firmly down into it so that it is fully inserted.
4. Secure the expansion card bracket to the system chassis using
the screw that held the slot cover in place.
PCI Slots
You can install 32-bit PCI interface expansion cards in PCI slots.
Slot1 only supports PC5 Slave mode. It is recommended you give
first priority to PCI 1~4 slots while inserting cards.
4x AGP Slot
The 4x AGP slot is used to install a graphics adapter that supports
the 4xAGP specification and has a 4x AGP edge connector.
The 4x AGP slot only supports 1.5V 4x AGP card.
Warning:
Please be sure DO NOT install 3.3V AGP 4X
VGA card on the mainboard, because it may cause the
malfunction.
21
CNR1
PCI1 PCI2 PCI3 PCI4 PCI5
AGP
Summary of Contents for M902 Series
Page 4: ...Mainboard User s Manual IV...
Page 30: ...Mainboard User s Manual 26...
Page 44: ...Mainboard User s Manual 40...
