Mainboard User’s Manual
WOL1: Wake On LAN
If you have installed a LAN card, use the cable provided with
the card to plug into the mainboard WOL1 connector. This
enables the Wake On LAN (WOL1) feature. When your
system is in a power-saving mode, any LAN signal
automatically resumes the system. You must enable this item
using the Power Management page of the Setup Utility.
Pin
Signal
1
5VSB
2
GND
3
-RING
Infrared Port
You can connect an infrared port to the mainboard. You can
purchase this option from third-party vendors.
1. Locate the infrared port
SIR1
header on the mainboard.
2.
If you are adding an infrared port, connect the ribbon
cable from the port to the IR header and then secure the
port to an appropriate place in your system chassis.
Pin
Signal
Pin
Signal
1
NC
2
KEY
3
+5V
4
GND
5
IRTX
6
IRRX
20
Summary of Contents for M902 Series
Page 4: ...Mainboard User s Manual IV...
Page 30: ...Mainboard User s Manual 26...
Page 44: ...Mainboard User s Manual 40...
