item is set to Delay 4 Sec. then you have to hold the power button
down for four seconds to cause a software power down.
State After PWR-Fail (Off)
This item enables your computer to automatically restart or return
to its last operating status after power returns from a power failure.
IRQ/Event Activity Detect
This item has several sub-items:
VGA (Off)
When set to On, the system power will resume the system from a
power saving mode if there is any VGA activity.
LPT & COM (LPT/COM )
When this item is enabled, the system will restart the power-saving
timeout counters when any activity is detected on the serial ports,
or the parallel port.
HDD & FDD (ON)
When this item is enabled, the system will restart the power-saving
timeout counters when any activity is detected on the hard disk
drive or the floppy diskette drive.
PCI Master (OFF)
When set to Off, any PCI device set as the Master will not power
on the system.
PowerOn by PCI Card (Enabled)
Use this item to enable PCI activity to wakeup the system from a
power saving mode.
Modem Ring Resume (Disabled)
Enable Modem Ring-in to resume the system.
RTC Alarm Resume (Disabled)
When set to Enabled, additional fields become available and you
can set the date (day of the month), hour, minute and second to
turn on your system. When set to 0 (zero) for the day of the month,
the alarm will power on your system every day at the specified
time.
36
