PCB Piezotronics M209C11, Installation And Operating Manual

Page: 16 / 17

Model Number
209C11
ICP® FORCE SENSOR
Revision: F
ECN #: 45224
Performance ENGLISH SI
Sensitivity(± 15 %) 2200 mV/lb 494,604 mV/kN
Measurement Range(Compression) 2.2 lb 0.00979 kN
Measurement Range(Tension) 1.0 lb 0.00445 kN
Maximum Static Force(Compression) 11 lb 0.0489 kN
Maximum Static Force(Tension) 1.0 lb 0.00445 kN
Broadband Resolution(1 to 10,000 Hz) 0.00002 lb-rms 0.00009 N-rms [1]
Low Frequency Response(-5 %) 0.5 Hz 0.5 Hz [2]
Upper Frequency Limit 30,000 Hz 30,000 Hz [3]
Environmental
Temperature Range -65 to +250 °F -54 to +121 °C
Temperature Coefficient of Sensitivity ≤ 0.05 %/°F ≤ 0.09 %/°C
Electrical
Discharge Time Constant(at room temp) ≥ 1 sec ≥ 1 sec
Excitation Voltage 18 to 30 VDC 18 to 30 VDC
Constant Current Excitation 2 to 20 mA 2 to 20 mA
Output Impedance ≤ 100 Ohm ≤ 100 Ohm
Output Bias Voltage 8 to 12 VDC 8 to 12 VDC
Spectral Noise(1 Hz) 0.0000044 lb/ √ Hz 0.0000197 N/ √ Hz [1]
Spectral Noise(10 Hz) 0.0000005 lb/ √ Hz 0.0000021 N √ Hz [1]
Spectral Noise(100 Hz) 0.0000001 lb/ √ Hz 0.0000006 N/ √ Hz [1]
Spectral Noise(1000 Hz) 0.0000000 lb/ √ Hz 0.0000002 N/ √ Hz [1]
Output Polarity(Compression) Positive Positive
Physical
Stiffness 2 lb/µin 0.35 kN/µm [1]
Size (Hex x Height) 0.375 in x 0.83 in 9.53 mm x 21.08 mm
Weight 0.29 oz 8.2 gm
Housing Material Stainless Steel Stainless Steel
Sealing Hermetic Hermetic
Electrical Connector 10-32 Coaxial Jack 10-32 Coaxial Jack
Electrical Connection Position Side Side
Mounting Thread 10-32 Female No Metric Equivalent
All specifications are at room temperature unless otherwise specified.
In the interest of constant product improvement, we reserve the right to change specifications without notice.
ICP
®
is a registered trademark of PCB Group, Inc.
M
- Metric Mount
Supplied Accessory : Model M081A05 Mounting Stud 10-32 to M6 x 0.75 x 0.27" long BeCu
(H900), no shoulder (1)
N
- Negative Output Polarity
Output Polarity(Compression) Negative Negative
W
- Water Resistant Cable
Electrical Connector Sealed Cable Sealed Cable
Electrical Connection Position Side Side
NOTES:
[1]Typical.
[2]Calculated from discharge time constant.
[3]Estimated using rigid body dynamics calculations.
[4]See PCB Declaration of Conformance PS023 for details.
SUPPLIED ACCESSORIES:
Model 081A05 Mounting stud, 10-32 to 10-32 x 0.27" long, BeCu (H900), no shoulder (1)
Model 084A38 Thermal boot (for Series 209) (1)
3425 Walden Avenue, Depew, NY 14043
Phone: 716-684-0001
Fax: 716-684-0987
E-Mail: info@pcb.com
[4]
OPTIONAL VERSIONS
Optional versions have identical specifications and accessories as listed for the standard model
except where noted below. More than one option may be used.
Entered: LK Engineer: MJK Sales: KWW Approved: APB Spec Number:
Date: 3/29/2016 Date: 3/29/2016 Date: 3/29/2016 Date: 3/29/2016
8891