Model Number
482B06
LINE POWERED SIGNAL CONDITIONER FOR ICP® SENSORS
Revision: B
ECN #: 43617
Performance
ENGLISH
SI
Fault/Bias Monitor/Meter
24 +/-1V V/FS
24 +/-1V V/FS
High Frequency Response(-5 %)
>1000 kHz
>1000 kHz
Low Frequency Response(-5 %)
<0.05 Hz
<0.05 Hz
[4][5]
Voltage Gain
1 +/-1%
1 +/-1%
Electrical
Supply Voltage
+24/Channel (+/-1V) volts
+24/Channel (+/-1V) volts
Sensor Excitation(Constant Current Source)
2-20 Channel mA
2-20 Channel mA
[1]
DC Offset(maximum)
<30 mV
<30 mV
Typical Spectral Noise(1 kHz)
0.03 µV/√Hz
-150 dB
[2]
Broadband Electrical Noise(1 Hz to 10 kHz)
3.64 µV
-109 dB
Typical Spectral Noise(10 kHz)
0.03 µV/√Hz
-151 dB
[2]
Typical Spectral Noise
(1 Hz)
0.87 µV/√Hz
-121 dB
[2]
Typical Spectral Noise
(10 Hz)
0.05 µV/√Hz
-146 dB
[2]
Typical Spectral Noise
(100 Hz)
0.03 µV/√Hz
-150 dB
[2]
Power Required(50 to 400 Hz)
115 +/-10%/0.12 (max) VAC/A 115 +/-10%/0.12 (max) VAC/A [3]
Maximum Output Voltage
± 10 Vpk
± 10 Vpk
Discharge Time Constant
10 (-0 +50%) sec
10 (-0 +50%) sec
[4]
Physical
Connector(Input)(Sensor)
BNC Jack
BNC Jack
Connector
(Output)
BNC Jack
BNC Jack
Connector
(AC Power Input)
IEC 320
IEC 320
Size (Height x Length x Width)
4.3 in x 6.0 in x 1.8 in
10.92 cm x 15.24 cm x 4.57 cm
Weight
1.2 lb
544 gm
All specifications are at room temperature unless otherwise specified.
In the interest of constant product improvement, we reserve the right to change specifications without notice.
ICP
®
is a registered trademark of PCB Group, Inc.
NOTES:
[1]Units supplied with current set at 4 mA (+/-0.5mA). User adjustment (external).
[2]Typical.
[3]Unit set to 230 VAC when ordered as F482B06.
[4]With ≥ 1M ohm input impedance of readout device.
[5]Un-buffered output, read out device input impedance affects discharge time constant and low
frequency response of unit.
SUPPLIED ACCESSORIES:
Model 017AXX Power Cord
3425 Walden Avenue, Depew, NY 14043
Phone: 716-684-0001
Fax: 716-684-0987
E-Mail: [email protected]
OPTIONAL VERSIONS
Optional versions have identical specifications and accessories as listed for the standard
model except where noted below. More than one option may be used.
Entered: AP
Engineer: CPH
Sales: ML
Approved: JWH
Spec Number:
Date: 2/3/2015
Date: 2/3/2015
Date: 2/3/2015
Date: 2/3/2015
9657
Summary of Contents for 482B06
Page 12: ......