23
Chapter 3: BIOS Setup Utility
ECP Mode DMA Channel (DMA3)
Use this item to assign a DMA channel to the parallel port.
Parallel Port IRQ (IRQ7)
Use this item to assign IRQ to the parallel port.
USB Functions (Enabled)
Use this item to enable or disable the USB function.
Legacy USB Support (Enabled)
Use this item to enable or disable support for legacy USB devices. Setting to Auto
allows the system to detect the presence of USB device at startup. If detected, the USB
controller legacy mode is enabled. If no USB device is detected, the legacy USB support
is disabled.
Power Management Setup Page
This page sets some parameters for system power management operation.
CMOS Setup Utility – Copyright (C) 1985-2005, American Megatrends, Inc.
Power Management Setup
ACPI Suspend Type
PWRON After PWR-Fail
Resume By RING
Resume By PCI/PCI-E/Lan PME
Resume By PS2 KB (S3)
Resume By PS2 MS (S3)
Resumeon RTC Alarm
Help Item
Select the ACPI
state used for
System Suspend.
S3
Power Off
DIsabled
Disabled
Disabled
Disabled
Disabled
: Move Enter: Select +/-/: Value F10: Save Esc: Exit
F1: General Help F9: Load Default Settings
ACPI Suspend Type (S3)
Use this item to define how your system suspends. In the default, S3, the suspend mode
is a suspend to RAM, i.e, the system shuts down with the exception of a refresh current
to the system memory.
PWRON After PWR-Fail (Power Off)
This item enables your computer to automatically restart or return to its operating
status.
Resume By RING
The system can be turned off with a software command. If you enable this item, the
system can automatically resume if there is an incoming call on the Modem. You must
use an ATX power supply in order to use this feature.
Resume By PCI/PCI-E/Lan PME
The system can be turned off with a software command. If you enable this item, the
system can automatically resume if there is an incoming call on the PCI Modem or PCI
LAN card. You must use an ATX power supply in order to use this feature. Use this item
to do wake-up action if inserting the PCI card.
