Paxar Mobile Work Station (MWS) Monarch 9878, Operating Instructions Manual

Page: 19 / 24

P R I N T I N G
5
To print supplies from a Monarch® 9825
ä
or 9855
ä
printer on the MWS,
using the 24VDC model is recomended:
1. Turn on the MWS' power supply and turn on the printer.
You see
PRINT MODE
Ready B
2.
Press Feed/Cut to calibrate the supply. You are now ready to
print.
To conserve the battery, make sure the MWS' power switch is turned OFF
when not in use OR when charging the batteries. For optimal (shortest)
charging time, turn off the MWS and printer while charging.
¨
If you need to finish a batch, you can print while charging, as long as the
batteries are not too depleted. However, printing while charging is
not
recommended on a frequent basis.
¨ If the printer will be unused for extended periods of time, we recommend
leaving the printhead unlatched.
¨ If the printer’s green power light blinks, you need to recharge the battery.
There is a small reserve of battery power to continue printing after the
green power light begins blinking.
¨
You must recharge the battery when you see error 762 or “Battery Dead”
on the display because the printer is in a “lock-up” condition and does
not print until the battery is recharged.
¨ The printer may slow down if the battery voltage drops below a certain
level. The printer continues to print at the reduced speed until the
batteries are charged and the printer is turned off and then back on.
See “Battery Life” in Chapter 3 for more information about charging
the batteries.
Printing
5-1