The 24VDC charger has a Power LED and five Percentage LEDs. When the
charger is turned off (power LED off), the percentage LED shows battery
status. The percentage LED flashes while charging to display battery status.
When the batteries are fully charged, the 100 percent LED stays on.
B a t t e r y L i f e
If you leave the battery charger plugged in and
constantly charging
when the MWS is not in use
,
the battery life is maximized for the application.
The charger does not overcharge the batteries.
The MWS has Battery Status LEDs to indicate the
battery status as follows (MWS power ON).
The following voltages are nominal (not exact)
and should be used for reference.
Flashing Red
Warning! The batteries need immediate charging.
Voltage is below 11.25V (one battery) or 22.5V (two
batteries). The MWS beeps (10 seconds beep on and
five minutes no beep) to alert you of this condition.
Flashing Yellow
Caution! The batteries are getting low. The voltage is
between 11.25V and 11.75V (one battery) or 22.5V and
23.5V (two batteries).
Flashing Green
Go! The voltage is above 11.75V (one battery) or 23.5V
(two batteries). The batteries are charged to
approximately 75% or better capacity.
Immediately plug the power cord into the wall socket and charge the
batteries when you hear a beep/chirp and the signal light flashes Red.
3-4
Charging the Batteries
1
1
0
0
%
8
5
%
7
0
%
5
0
%
3
0
%
Battery
Status
LEDs
1
100%
85%
70%
50%
30%
Percentage
LED
Power
LED
Summary of Contents for Mobile Work Station (MWS) Monarch 9878
Page 10: ...2 4 About the MWS Unit ...
Page 16: ...3 6 Charging the Batteries ...
