Appendix C:
8. Thread the cutter cable through a hole (8) and route it to JP13
connector(CUTTER).
INSTALLATION for
DISPENSER and REWINDER
1. Turn off the printer.
After the cutter is installed, install media and ribbon.
2. Remove the top covers on both left and right sides.
3. Set bit 5 of DIP switch (1~8) to ON position.
1. Put the media end on the roller.
4. Refer to the diagram. Assemble the related components for both left
and right sides.
2. Close the TPH latch.
3. Hold the PAUSE/CALIBR button and turn on the Printer.
4. Release the button when the cutter starts cutting.
5. After cutting the Printer will feed the label for 12 inches.
Notes:
The above procedure is taken at first time after installation or cutter jam.
Normally the Procedure is
1. Put the media end on the roller.
2. Close the TPH latch.
3. Turn on the printer.
4. Press the FEED button to let the media end go through the cutter.
64
63
